上海颜乐缝纫设备有限公司
地 址:上海奉贤肖塘北虹路96-102号
电 话:021-57431873
传 真:021-57431873
手 机:13651939592
联系人:杜经理
 
 
四针六线绷缝机过骨位时最左边第二根针出现跳针、断线的调整
作者:管理员    发布于:2014-02-26 14:22:44    文字:【】【】【
摘要:四针六线绷缝机过骨位时最左边第二根针出现跳针、断线的调整

 考虑到跳针、断线是在过骨位时产生的,建议按下列要求进行调整和处理。
    (1)把机针换粗一号,以增加机针强度。


    (2)把钩针勾线时间对慢些,有利于线环充分形成。


    (3)把针杆降低一点,保证钩针从线环中间通过,减少跳针断线机率。


    (4)对缝线加硅油润滑处理,以降低线的捻度,减小摩擦。


    (5)建议检查针夹头的各针孔位是否准确,如不准确需调换。

Considering that jump needle, bolt is produced when a rib, suggest adjustments according to the following requirements and processing.
(1) put the needle in the coarse one, to increase the intensity of needle.


(2) the crochet to cancel the time slowly, is advantageous to the wire ring form in full.


(3) reduce the needle bar, ensure crochet ring through the middle from the line, reduce probability jump needle break line.


(4) to suture with silicone oil lubrication processing, in order to reduce the twist wire, reduce the friction.


(5) suggest to check the needle clamp the pinhole is accurate, such as inaccurate need changing.

脚注信息
 沪ICP备13010829号-2 上海颜乐缝纫设备有限公司 版权所有 2013-2018  技术支持:合扬网络    本站关键词:上海缝纫机回收,上海回收缝纫机,上海出租缝纫机 
分享到: 0